WM800 - CONTACT SENSOR_1501
search
  • WM800 - CONTACT SENSOR_1501

WM800 - CONTACT SENSOR

Stelle eine Frage
WM800 - CONTACT SENSORWM800 - CONTACT SENSORCHF 0.00

Ihre Anfrage wird gesendet.

  •     *Benötigte Felder

Laden

  Lieferung

Wir liefern weltweit mit DHL, DPD, Spedition

  Qualität

Wir liefern nur Originalteile, direkt vom Hersteller.

A rotary potentiometer position sensor, in which a conductive wiper is in contact with a complex resistive material.

The WM-800 is a rotary potentiometer position sensor, in which a conductive wiper is in contact with a resistive material. The wiper is attached to a rotor. As the rotor is moved in either direction there is a change in the resistance, which is proportional to absolute rotation.

Typical output signals can include:
- Two electrically-isolated linear ratiometric outputs
- One linear ratiometric outputs and up to two idle validation switch (IVS) circuits


Ratings are as follows:

Electrical:
- Linear ratiometric circuits operate from ±5VDC supply
- IVS circuits operate up to 28VDC dependent on configuration and the input electric load

Mechanical:
- Packard Electric “Metri-Pack” Series 150 Connector
- Up to 54° of rotation
- 10-million endurance cycles
- 40-million dither cycles

Environmental:
- Williams Controls Environmental Test Specification WDS-010
- Ingress protection ratings IP66

Note:
These specifications represent the expected minimum performance of the sensor. This information does not constitute a warranty that the product will meet the above specifications while used in specific applications or test equipment. Specific requirements may vary, based on the sensor configuration.
Neu